Cattle Hoof Trimming Disc With 6 Blades

Product Description

The purpose of hoof trimming for breeding cattle and sheep is to remove the overgrown horny part as well as to restore the uniform weight-bearing between the hooves and toes, repair the damage, etc. First of all, bind the cattle on the hoof trimming fixing frame, pay attention to protect the cattle when fixing them, and pay attention to the position of the lap band fixing, the rear lap band should be fixed above the back of the hip bone of the cattle, at the same time, pay attention to avoid the nipples to prevent the lap band from damaging the fetus and the nipples. Before hoof trimming, do a hoof inspection, mainly measuring the length of the hoof nail, which is the area from the hardened part of the toe to the end of the toe. The standard for judging the length of the hoof nail is 7.5 to 8 cm for a normal front hoof. If a cow’s hoof is not trimmed for a long time, too many cuticles may accumulate between the toe joints on the bottom of the hoof, affecting the health of the hoof. The hoof box is the weight-bearing part of the hoof, it is the keratinized shell part of the hoof wall that protects the senses and supports the weight. Trimming out the correct arch of the hoof is the basis for re-establishing the balance system of the cattle limb and hoof. The long hoof is most likely to hurt the teats and udder of dairy cows, especially when the cow is lying down frequently before and after delivery, and when the udder is enlarged during lactation. When repairing the hoof, you should pay attention to the fact that there are often small bleeding surfaces on the bottom of the hoof, which is called a bruising surface. If there is a bruised surface on the hoof, it indicates that the hoof flap has been damaged, which is usually related to excessive weight-bearing or ulcers on the sole of the hoof.

The bottom of the cow’s hoof should not be repaired too thin, especially not cut bleeding, otherwise, it will hurt the cow’s perceptual nerve. Hoof repair should be before the onset of the rainy season, too early to repair, hoof horn hard and difficult to remove; too late to repair the hoof, the day is hot and rainy, the environment is muddy, and not suitable for care, easy to occur infection. For sick cattle that are already lame, the sick hoof should be repaired first, then the healthy hoof. The hoof trimming process should be as quick as possible, do not delay to prevent the cattle from being bound to the hoof trimming frame for too long, the cattle’s legs will be paralyzed, unable to bear the body weight, and lead to paralysis, if the cattle are temporarily unable to stand, you can use moderate stimulation to assist the cattle to stand. After completing hoof trimming, cattle should be placed in a clean, dry pen, thus ensuring clean hooves and preventing infection.

We provide hoof trimming discs with 7 blades and hoof trimming discs with 4 blades for our customers.

In addition to shoe repair knife plate, cattle stomach suction stone, animal crayon, Penn State Particle Separator, Cow/Cattle Digestion Analyzer, cattle breeding artificial insemination products, cattle cow farm colors identification tape, piston milking machine, vacuum pump milking machine, cattle with integral ear tag and cattle with split ear tag are necessary supplies in cattle farm breeding products.

Product Feature

1. Aluminum alloy knife disc ultra-light material, hardening treatment without deformation, good stability, appearance design: fast heat dissipation, can observe the situation of repairing hoofs at any time.
2. The knife grain position of the knife plate is designed to repair the hoof area is large, and improve the efficiency of repairing the hoof.
3. The knife grain is an imported rare metal alloy knife grain, with high density, good toughness, and excellent wear resistance.
4. After use for a period of time, the knife grain is rotated 180℃ and used as the new one, which has a long service life and saves the user cost.

Product Parameter

6 shoe trimming blades

HS Code: 8213000000